Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 8, 2019 at 10:17 am #26452
    LTT
    Participant

    Enable “CTRL + Wheel to Change Font Size”.
    It’s good that the Recent Font list saves the size only when I release the mask keys.

    1:
    Is it possible to make “Increase/Decrease Font Size” commands also behave that way, when I hold the shortcut key?

    2:
    Is it possible to show the font size in the status bar temporarily when either way is being used?

    December 9, 2019 at 11:32 am #26464
    Yutaka Emura
    Keymaster

    We will implement these on the next version.

    December 14, 2019 at 3:33 pm #26499
    LTT
    Participant

    >1:
    I expect the sizes will NOT be saved in Font List during adjusting.
    But now even Ctrl+wheel saves the sizes…

    3:
    Add an “*” (or some character) in Status bar when font size matches the default size.

    4:
    Also show font size in Status bar for “Reset Font Size” command.

    December 15, 2019 at 9:51 am #26500
    Yutaka Emura
    Keymaster

    I couldn’t reproduce 1. The sizes are not saved during adjusting except only when the CTRL key was depressed. However, I fixed another issue, please check the next version again.

    3. will be implemented on the next version.

    Also fixed a bug related to the Reset Font Size command.

    December 20, 2019 at 3:09 pm #26520
    LTT
    Participant

    1+:
    If the shortcut contains neither Ctrl+ nor Alt+ (e.g. Shift+F11), the step changes will be saved.

    2+:
    If I don’t use the shortcut key,
    or I don’t have “Ctrl+” in the shortcut,
    “Increase/Decrease Font Size” command leaves the message in the status bar. (Though pressing Ctrl key will clear it.)

    5:
    The commands don’t move the saved item to top in the menu.

    New suggestions:
    + Command: Set Current Font as Default.
    + Command: Reset Font.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.